How to Unlock iPhone with 1.1.1

This tutorial assumes that your iPhone has firmware version 1.1.1. update it to 1.1.1 first or Read here first if you’ve already unlocked your phone before.

How to Bypass activation and prepare iPhone for software installation

1. Make sure you have turned off your SIM-card with PIN turned off, and power on your phone
2. On the activation screen, slide for emergency and dial:
   *#301# to make the phone call itself. ( just dial 0 If the incoming call dialog suddenly disappears but it still ringing,(remove *#301# first), and it will call itself)
3. Answer the call, and tap on Hold
4. Phone will call it self again, tap Decline. You will now be returned to the normal dialer.
5. Tap on contacts, and tap the + icon to add a new. To add a URL, tap Add new URL. The first URL is prefs followed by a colon: prefs: and the second is i.unlock.no. Tap Save.
6. Your contact now has two “web pages” - tap on the first one (prefs:). This will take you to the settings dialog. tap on Wi-Fi, and connect to a network, and make sure that you are connected, see the icon on top of the screen that indicates you are connected. Then set:
   General ? Auto-Lock ? Never.
7. Now, press the home button, and again, slide for emergency dial 0, Answer the call,
   Hold and Decline the new call so that you get to the contacts. Tap on your contact (No Name), and this time tap on the other home page, i.unlock.no
8. Safari will launch and show you a webpage. Tap on Tap here to jailbreak your iPhone
9. Phone will return to activation screen and after a few seconds the phone should restart.
10. If itsn’t not restart after a full minute, please make sure that you have your phone connected to the computer and try again.
11. When the phone starts again, it should no longer say slide for emergency, but rather Slide to unlock It means it was successfull! Activation is now bypassed, and phone prepared for software
    installation! (If you are going to use an AT&T SIM, you won’t need to do the next step.)

Unlock the SIM-lock on jailbroken 1.1.1

1. Open installer, and install the update if prompted.
2. Go to sources and tap Edit and Add
3. Add this URL: http://i.unlock.no
4. Tap Done and then Refresh
5. Go to Install (at bottom) and scroll down to the Unlocking Tools category and install AnySIM
6. You can press the home button when it’s installed , and you will find a new AnySIM icon on your home screen. Launch it and follow the instructions.
7. The process will take about 5-10 minutes, in the end it should say it was successful!
8. Launch Installer and uninstall AnySIM. Then go to
   Settings ? General ? Auto-Lock and set it to a preferred value.

Now you’re done

• How to get iPhone “virgin” and Restore Baseband
• iPhone’s DFU Mode (Device Firmware Upgrade) / Recovery Mode
• Nokia 6600 slide, Well-Balanced and Compact
• Rotary phone 4-port USB Launches
• m-Book TW800, comes in 3 Versions